Наружная IP-камера с Wi-Fi и функцией ночного видения

Check if you have completed the installation, including selecting your WiFi network. Check to be sure the following
steps:

• On the reset cable you will find a reset button. Press this button for ten seconds until the device will ''pining''.
• Leave the camera alone for five minutes so he can restart.
• Go to your WiFi settings and wait untill an IPCH number appears. Press on the IPCH number and when you see ''forgot'', then press on that and go back to the app.
• Remove the camera in the app and install the new camera.
• After you have seen the first image, press on the check mark, arrow or further (this differs per device).
• There will be asked for your network data. Fill these in and restart the camera. 
• After the camera restarted you will get a confirmation. 
   

Customize the detection sensitivity at the setting of the camera. Or disable the motion detection completely. 

Go to the settings of the camera and turn on ''detect movement'' and link to a notification interval. 

That unfortunately not possible. The camera can be signed up seperately in the home screen of the Smart Home app so that you can check the camera in a separate camera environment.

Yes that is possible. There is no limit to the number of cameras that can be registered in the app. 

Yes that is possible. 

When a new firmware is available for the IP camera the option Update Firmware becomes available. Press Update firmware to download and install the latest firmware for the IP Camera. After the new firmware is downloaded and installed the camera will reboot.

With nightvision mode you can select if the camera must switch automatically to night vision when there is not enough surrounding light. Or set it to manual so the nightvision can be switched on or off manually. 

Press on Video Quality to change the video quality. An overview is shown of the different picture settings. Then select the desired quality. After that the app will return to the settings screen. 

When the video stream has been recorded you can view the recording by pressing View recordings.  A new screen is opened with an overview of the recorded video streams. Press the recording you want to view.

Yes that is possible. Go to ''View recordings'' and select the video.To download the recorded video press the download button on the bottom of your screen.

If you have lost the connection with the camera, your IPCAM might have lost the WiFi connection. Restart your camera by cutting the power off for some seconds. After about five minutes the camera will be restarted again and the connection should be restored. 
 

To reset the camera, open the cap of the reset cable and press the reset button for about 10 seconds. The camera will be set and restarted. After the restart the blue LED will light up. 

Unfortunately, we do not have service centers to repair products.
A defective product should be replaced by your point of purchase during the warranty period.

We offer a 'return to retailer' warranty on our products. In case of a defect, you can return the product to your retailer with failure description, proof of purchase and all accessories. During the warranty period you will receive a replacement product from the retailer if available. For full warranty conditions you can consult: https://www.trust.com/support/warranty

That is not possible.