Currently available
Paxxon
1500VA Uninterruptible Power Supply (UPS)
Reliable 1500VA battery back-up UPS with 4 wall power outlets, suitable to power and protect your electronic devices
The Ultimate Backup
You can rest easy, knowing that the Trust Paxxon 1500VA is keeping an eye out for your devices. The reliable UPS is an ideal secondary power source to your electronics, keeping them running temporarily during power grid blackouts, and protecting them from power surge damage.
Key features
High Capacity
With 4 standard wall power outlets, the Paxxon is equipped to protect whatever device or peripheral is connected to it: computer, TV, gaming console, home automation or alarm system, router or modem, or other wall-powered devices. With its high-capacity battery, you can connect devices up to a maximum total of 900 Watts or 1500VA.
Safe Shutdown
During a blackout, the UPS’ large battery generously covers the power needs of an average PC setup. With 7 minutes of runtime* to save your work and safely shut the system down, the quality of your files and equipment is guaranteed to be maintained. Even at full use of the 900W capacity, this UPS can keep your systems fully operational for 80 seconds.
* At 450W capacity load
Extra Options
Paxxon’s USB connection and downloadable PC software enable you to program the UPS to execute an automated shutdown, in case of a power outage. If you’d rather save your work and power off manually, the software allows you to set custom visible and audible signals to alert you, as well as monitor the power supply status at all times.
Stable Output
Thanks to the AVR function, the UPS will maintain a stable output voltage. In the event of power surges or spikes, your equipment is in safe hands. So safe, that we’re offering an extended warranty of up to € 20.000 on connected equipment.**
** Check conditions on trust.com
product-specifications
Specifications
General
Height of main product (in mm)
182 mm
Width of main product (in mm)
130 mm
Depth of main product (in mm)
320 mm
Total weight
10000 g
Weight of main unit
10000 g
Features
Management function (USB)
yes
USB connection
yes
Status display
no
Audible alarm
yes
Software
yes
Control
Indicators
Battery, Battery empty, Charging, Overload, Power
Connectivity
Cables included
USB-B to USB-A
Cable detachable
no
Cable length main cable
140 cm
Protection
Protections
current-recoil, over-charge, over-cranking, over-current, over-discharge, over-heat, over-load, short-circuit
Auto Voltage Regulation
yes
RFI-filter
no
Surge protected AC outlets
yes
Surge protected phone line
no
Power
Number of batteries
2
Battery composition (Alkaline, Li-ion, etc.)
Lead Acid
Power inlet connection
Schuko (Type F)
Power outlet socket type
Schuko, Type L
Battery capacity (Ah)
9 Ah
Battery voltage (V)
12 V
Number of power outlets
4
Battery charge time (hours)
8 hours
100% capacity runtime (seconds)
80 seconds
50% capacity runtime (minutes)
7 minutes
Input
Nominal input voltage
220-240Vac
Operating voltage range
162-290Vac
Output
Output power capacity (W)
900 W
Output power capacity (VA)
1500 VA
Output voltage range
nominal voltage
Frequency response UPS
50Hz +/- 1Hz
Waveform type
simulated sine wave
Extra information
Item number
23505
EAN code
8713439235050
Warranty
1 year
Package contents
UPS unit
USB cable
User guide
System requirements
- Grounded wall power connection
- For software: Windows 10/8/7, USB port
- 155MB of free hard disk space
- Latest software downloadable from:
- www.trust.com/23505/driver
Downloads
Downloads
drivers
Drivers
Version 2.0 | Multilingual | Windows 10
09/04/2020
ViewPower UPS software
Version 1.0 | Multilingual | Windows 10
22/08/2019
ViewPower UPS software
leaflets
Leaflets
English
Commercial leaflet
Type: pdf
English
Extended commercial leaflet (not a guidebook)
Type: pdf
Legal & Compliance information
Version 1.7 | Multilingual
Legal & Compliance information
faq
FAQ
Frequently Asked Questions (FAQ)
- First let the UPS charge overnight: plug it in, turn it on, and with no load attached, let it charge for at least 9 hours.
- When the UPS is fully charged, connect the equipment to the UPS. Make sure to not exceed 900W.
Drivers are available in the downloads section.
Each model of UPS is capable of handling a predetermined amount of power draw. Always make sure that the wattage draw from your equipment plugged into the outlets does not exceed the Watt rating. The Watt rating of your UPS is 900W.
- Green LED: This indicates that the UPS is operating normally on utility power from your wall socket.
- Yellow LED plus sound: This indicates that your UPS isn't operating on utility power from your wall socket. Check the wall power, and cabling.
- Red LED plus sound: This indicates an error, and can have 2 reasons:
1. The equipment connected to the UPS is drawing more power than the UPS can provide. Each model of UPS is capable of handling a predetermined amount of power draw. Verify that the wattage draw from your equipment plugged into the outlets does not exceed the Watt rating.
2. The battery is near the end of its useful life. It is a warning that the battery needs to be replaced. It does not necessarily mean that the battery is dead. The typical life span of the battery is 2-4 years depending on use and environment (temperature). Before replacing the battery, however, you should let the UPS charge overnight (leave it plugged in, turned on, and with no load attached). Then test the UPS. If the UPS fails the test and the unit is still in warranty (2 years from date of purchase), contact our support for further troubleshooting. If the unit is out of warranty, a replacement battery should be ordered from your local retailer.
Modern batteries do not require this, but is optional.
Backup time is highly dependent on what type of PC is connected.
The time mentioned on package/website is the maximum backup time.
The time mentioned on package/website is the maximum backup time.
Please check if the circuit breaker on the back of the device has tripped. If so, the button labeled “press to reset” should have sprung out. When this is the case, please turn off the UPS, disconnect all attached devices and press the button on the back. This will reset the circuit breaker.
After resetting the circuit breaker, please turn on the UPS to see if it works and reconnect the devices one by one.
In the event that the UPS won’t turn on after resetting the breaker, please contact our support team via the 'ask a question' option on the product page.
If your UPS is still under warranty (the warranty term for UPS is 2 years), we suggest you to get in contact with your retailer and replace it under the proof of purchase.
If your UPS is no longer covered by warranty and you want to replace the battery, you can find a suitable battery in special stores or on the internet.
If your UPS is no longer covered by warranty and you want to replace the battery, you can find a suitable battery in special stores or on the internet.
The UPS outputs a so called "stepped sine" voltage.
Some voltage meters misunderstand this and display a wrong voltage.
Note: Connected devices won't have any problem with this stepped sine voltage.
Unfortunately, we do not have service centers to repair products.
A defective product should be replaced by your point of purchase during the warranty period.
We offer a 'return to retailer' warranty on our products. In case of a defect, you can return the product to your retailer with failure description, proof of purchase and all accessories. During the warranty period you will receive a replacement product from the retailer if available. For full warranty conditions you can consult: https://www.trust.com/support/warranty
This particular product has been developed for use with the Windows operating systems only.
Therefore drivers or installation instructions for other operating systems such as Mac are not available.
supportMail
Contact us
Contact us
Please check our FAQs first, chances are you'll find the answer there.
Couldn't find the answer in the FAQs? Fill out the form below with as much information as possible and one of our help-desk staff will respond at the earliest opportunity. Our messages are answered in the order they are received.
After submitting the form a confirmation message will be displayed with your reference number. The confirmation will be sent to your email address at the same time as well. If you have not received the confirmation message, please check your spam or junk mail folder. Otherwise, fill out the form again with your correct e-mail address.